I have successfully attached and setup my Envisalink 4, but my Honeywell system hasn't been used in a while and now includes some zones that are no longer in use. For example, some of the windows have been replaced & the smoke detectors have been replaced by non-Honeywell versions. Also, the Honeywell battery is dead.
How do I:
1) Disable the obsolete zones?
2) Disable the battery warning?
I have an ATD SafeWatch Pro 3000 keypad.
The beeping is driving my wife insane and I will need to return my Envisalink 4 if I don't figure this out...
Information and support for EnvisaLink modules.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 42 guests