Tamper reporting and TX delay to central station with EVL4

Information and support for EnvisaLink modules.

Moderators: GrandWizard, EyezOnRich

pedals2paddles
Posts: 1
Joined: Sun Aug 01, 2021 8:07 am

Tamper reporting and TX delay to central station with EVL4

Postby pedals2paddles » Sun Aug 01, 2021 8:28 am

Good morning. Three questions for you all. I have a DSC1832, EVL4, and Eyzon monitoring over ethernet/internet.

[*] How can I disable tamper reporting to the central station? I have set 00 in the tamper/restoral reporting codes (330-337). And I have disabled all the tamper/restoral call directions (359). But the central station is still notified immediately and calls me.

[*] Why is the transmission delay zone attribute ignored? I have a few zones with the #7 TX Delay attribute set. But that zone reports its alarm to the central station immediately. Note, I am not talking about a delayed entry zone. I'm talking about the TX delay zone attribute. The zone goes into alarm immediately, but my expectation is the transmission to the central station is delayed for X seconds.

[*] Does the Communication Cancelled Message (third communicator options 382 #3) actually do anything?

GrandWizard
Posts: 2078
Joined: Tue Nov 16, 2010 4:08 pm

Re: Tamper reporting and TX delay to central station with EVL4

Postby GrandWizard » Mon Aug 09, 2021 10:07 am

Submit a tech support request from your Eyezon portal as these questions are way above my pay grade. One of our Honeywell technicians will be able to help you.


Return to “EnvisaLink ( IP100D, IP170D, 2DS, 3, 4)”

Who is online

Users browsing this forum: No registered users and 11 guests