I have a honeywell Vista 20P panel with a Envisalink 4. I'd like to trigger Alexa based routines when the alarm is triggered (either smoke/heat or intrusion). As an example, if the alarm goes off, I want to turn all the lights inside and outside of the house to turn on.
I do see a smoke/heat device under Alexa status, but all I see is that it is "closed" and a message that says "server is unresponsive." All other Evisalink sensors (doors, etc.) show the same status. I can't seem to select any of them to build a Alexa routine.
I've searched the forum and could not find a solution. Any thoughts on how to do this? If this is not possible, I may add a SONOFF SV to the alarm output of the panel. But seems I should be able to do this from the Envisalink 4.
Thanks in advance for any assistance!
Information and support for EnvisaLink modules.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 10 guests