Hi, been wanting to try creating partitions for some time now and finally got around to it. I created 3x partitions, Partition 1 - All Exterior and Interior Beams/ PIR's, Partition 2 - Exterior Beams only and Partition 3 for Interior PIR's.
As for as I can see, I've enabled the partitions under section  and the individual zones are selected under the partition zone assignment  to , done as follows:
The issue I have for Partition 2 (Exterior) & 3 (Interior) is that it does not show the zones and something I picked up is that even if a zone is opened, I can still activate arming in Partition 1(Exterior & Interior). For now I've just disabled Partition 2 & 3, until I can get some help to figure out what I've missed?....
Information and support for EnvisaLink modules.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 12 guests