If I have the front door open when arming the DSC Power Series alarm from the 5500 panel with code it works excellent.
If I arm over the Envisalink API with code 033 I get an error back when the door is open (works if the door is closed though..). The error is according to API spec..."System Not Ready to Arm(system is either not-secure,in exit-delay,or already armed)".
Code (Partition Arm Control – With Code)
The TPI will attempt to arm the selected partition by using a User Code. This is equivalent to entering a User Code while the partition is in the Ready mode.
Yes I can see the API spec about 033 says it is equivalent to arming on the panel if in ready mode. And if the door is open, it is not in ready mode... Som my real question is. As the panel arming accept to ARM even if a zone (i.e front door is open) is open, isn't it possible to to the same in the API? I want the exact same behaviour in the API as when arming on the panel...