I am trying to send cmd 200 ([Access Code]) after the panel sends cmd 900 due to an access code being required for a bypass action.
However, I am always getting the error "IT-100/Envisalink Error (026): API User Code not Required."
According to the TPI manual:
The application will have the panel’s time window for entering the access code. If a command 200 is issued to the TPI outside of the panel’s window, system error 26 (Command not Required) will be issued.
What is happening here? How long is the panel's time window? I tried short delays before sending the 200 command with no success.
Information and support for EnvisaLink modules.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 16 guests