Control Panel time sync does not work

Information and support for EnvisaLink modules.

Moderators: EyezOnRich, GrandWizard

Posts: 3
Joined: Sun Oct 18, 2015 7:06 am

Control Panel time sync does not work

Postby Unicornis » Sat Oct 24, 2015 1:08 pm

I cannot synchronize the panel time to the network time. It does not work from EYEZ-ON app, neither from an OpenHAB app.

Everytime the 010 command is sent to EVL-4, it gets acknowledged by 500 response, but 5 seconds later I get 502 response with code 011: Keybus Transmit Time Timeout

Any ideas? The unit is connected to the control panel with ca 7m cable, which then goes to the keyboard. I do ot think it is an issue, as everything else works just fine.

Thanks in advance for any hints.


Return to “EnvisaLink ( IP100D, IP170D, 2DS, 3, 4)”

Who is online

Users browsing this forum: No registered users and 12 guests